Fire-Safe
Flame Retardant for Hay and Straw
Product Information:
Fire-Safe is a Class A interior flame retardant saturant for use on Hay or Straw. This product is ready to use. The hay or straw will look and feel exactly the same after Fire-Safe is applied. Hay or Straw must be treated with Fire-Safe a minimum of 48 hours prior to use.
Technical Data:
-
Fire-Safe covers 200 square feet per gallon.
-
Appearance - clear in color, consistency of water, no odor.
-
Weight - 5-gallon pails weigh 43 lbs.
-
Storage - do not allow to freeze. Store between 40° and 80°F. Keep cap on container at all times.
-
Shelf life is 5 years if properly stored.
-
Do not add water or alter Fire-Safe in anyway.
Approvals:
NFPA, 701 small scale, California Approval No. C-21302
Application Instructions:
Before using, User must determine the suitability of this product for its intended use. User must wear chemical gloves, goggles and respirator. Hay or Straw must be completely dry and clean of dirt and pesticides. Apply Fire-Safe with a 40-60 PSI Hudson or other common garden sprayer. Spread out Hay or Straw in order for chemical to reach all sides and all sections of Hay or Straw. If bails are being treated, enough chemical must be applied heavily to all exposed areas of bail for saturation of chemical. Recommended coverage is 200 square feet per gallon making sure that all exposed sides of the hay or straw is completely saturated. Allow a minimum of 24 hours for Hay and Straw to dry. This time will vary depending upon atmospheric conditions. After Hay or Straw is dry, allow 24 hours for curing before chemical will be effective.
Clean Up:
Flush sprayer and tips with warm water and wash hands with soap and water.
Caution:
Keep out of reach of children. Do not ingest. Call physician if swallowed. Clean with soap and water all contacted areas. If chemical gets into eyes, flush eyes with chemical eye wash or flush eyes with cool water for at least 15 minutes. If irritation persists seek advice of a Physician.
Warranty and Disclaimer:
Use only as directed. Sellers and Manufacturers only obligation shall be to replace such quantity of the product proved to be defective. Neither seller nor manufacturer shall be liable for any injury, loss or damage, direct or consequential, arising out of the use of or inability to use the product. Before using, user should determine the suitability of the product for its intended use. The user assumes all risk and liability whatsoever in connection therewith. Any statement or recommendation not contained herein shall have no force or effect unless contained in an agreement signed by officers of seller and manufacturer. Deterioration of coatings applied to interior finishes can occur due to atmospheric conditions, repeated cleaning of the surface or painting over applied coatings. Fire Retardants shall possess the desired degree of permanency and shall be maintained so as to retain the effectiveness of the treatment under the service conditions encountered in actual use. Periodic testing and inspection should be performed to insure flame-retardancy.