|
| |
|
TREE-SAFE
Printable PDF of Product Data
Sheet
FLAME RETARDANT LATEX BASED
COATING FOR CHRISTMAS TREES Call for pricing -
Order Form (PDF) |
PRODUCT DESCRIPTION:
Tree Safe is a non-hazardous; non-toxic Class 1 interior latex based paint
for use on Christmas Trees. This coating comes in a beautiful green color
that looks just as natural as the tree color itself. Tree Safe helps to keep
the needles intact and helps to preserve the tree. There is no tacky feel to
the tree after drying.TECHNICAL DATA:
 | Once applied and dried, do not use harsh detergents on surface |
| Apply two coats |
| Application rates will vary based on fullness of the tree |
| Appearance - consistency of paint: available in green, white and
color base for custom color mixing |
| Weight - 5-gallon pails weigh 60 lbs. |
| Storage - do not allow to freeze. Store between 40° and 80°F. |
| Shelf life is two years if pails are unopened. |
APPROVALS:
California State Fire Marshal #C-21301, Section 1264 & 1237, Class 1 flame spread.
APPLICATION PROCEDURES:
Before using, user must determine suitability of this Tree Safe for
its intended use.
| Applicator must wear paint goggles, respirator and gloves. Mix
Tree-Safe well. |
| Tree must be clean of loose branches and needles. Tree must be
completely dry before applying Tree Safe. Apply Tree Safe with airless
paint sprayer. |
| Make sure that every exposed area of the tree is heavily covered
including top, bottom and sides of every branch. Also, the entire tree
trunk must be covered except for the bottom of trunk to allow for water
absorption. Let tree dry and cure for 24 hours prior to applying 2nd
coat. In addition, tree must be kept dry and out of the rain for the
life of the paint. |
| Note: Christmas trees have performed well in exterior
applications with an additional coat of FR-10 clear flame-retardant
coating. However, exterior testing is not complete for this type of
application. Allow tree to completely dry before adding any decorations.
When tree is ready for placing into an approved stand, cut 1" off of
bottom of tree trunk which will allow for maximum water absorption by
tree. |
| Tree must be placed in an approved tree stand that holds sufficient
water for tree absorption. Check water level on a daily basis or as
needed to ensure water absorption by tree. |
| Do not add water or change chemical composition in any way. |
| Always make sure cap stays on container. |
CLEAN-UP:
Flush sprayer and clean equipment with cold water and wash hands with soap and water.
CAUTION:
Keep out of reach of children. Do no ingest. Call physician if swallowed. Clean with soap and water all contacted areas. If chemical gets into eyes, flush eyes with chemical eye wash or flush eyes with cool water. If irritation persists seek advice of a Physician.
LIMITATIONS:
Do not add water or change chemical composition in any way. Always make sure cap stays on container.
WARRANTY AND DISCLAIMER:
Use Tree Safe flame retardant only as directed. Sellers and Manufacturers only obligation shall be to replace such quantity of the product proved to be defective. Neither seller nor manufacturer shall be liable for any injury, loss or damage, direct or consequential, arising out of the use of or inability to use the product. Before using, user should determine the suitability of
Tree Safe for its intended use. The user assumes all risk and liability whatsoever in connection therewith. Any statement or recommendation not contained herein shall have no force or effect unless contained in an agreement signed by officers of seller and manufacturer. Fire Retardants shall possess the desired degree of permanency and shall be maintained so as to retain the effectiveness of the treatment under the service conditions encountered in actual use. Periodic testing is recommended.
Revised 01/06
|
|
