PRODUCT DESCRIPTION:
Firetect PC-201 provides effective fire retardancy for polyurethane, polyester and polyethylene foams and other cushioning materials. PC-201 is formulated in a water base system which eliminates the hazards and toxicity associated with solvent systems. PC-201 will not affect the resiliency of the foam or padding material in any way. The treated surface will not wash out, migrate or decompose. Additional tests have shown that the treated surfaces have improved resistance to oxidation and other forms of chemical deterioration; therefore, better life can be expected from materials treated with PC-201.
TECHNICAL DATA:
Appearance - consistency of paint: available in white, black and custom colors. Density - 1 gallon bottles weigh 10 lbs. 5 -gallon pails weigh 5 5 lbs. Storage - do not allow to freeze. Store between 40' and 80'F. Shelf life is two years if containers are unopened.
APPROVALS:
Military specification MIL 100A as per drawing #10250742-1. In addition it enables this material to meet the Department of Commerce standards for carpet padding under DOC FF 1-70 and DOC FF 2-70, and the Federal Motor Vehicle Safety Standard No. 302.
APPLICATION PROCEDURES:
Mix thoroughly before using. Surfaces should be clean of all dust and dirt before applying. May be applied with airless spray, brush or roller; however, do not thin anymore than is necessary for application. Apply two generous coats of material over the surface to be protected. Apply 75-200 square feet per gallon in two coats. (1 gallon will cover a total of 35-100 square feet). Cover entire exposed area. Make sure first coat is completely dry before applying second coat. Certification requires application by a California State Certified Applicator to comply with requirements of the California State Fire Marshal.
CLEAN-UP:
Flush sprayer and equipment with water and wash hands with soap and water.
CAUTION:
Do no ingest. Call physician if swallowed. Clean with soap and water all contacted areas.
LIMITATIONS:
Do not add water or change chemical composition in any way.
WARRANTY:
PC-201 will perform only if directions are followed. Sellers and Manufacturers only obligation shall be to replace such quantity of the product proved to be defective. Neither seller nor manufacturer shall be liable for any injury, loss or damage, direct or consequential, arising out of the use of or inability to use the product. Before using, user should determine the suitability of the product for its intended use. The user assumes all risk and liability whatsoever in connection therewith. Any statement or recommendation not contained herein shall have no force or effect unless contained in an agreement signed by officers of seller and manufacturer. Fire Retardants shall possess the desired degree of permanency and shall be maintained so as to retain the effectiveness of the treatment under the service conditions encountered in actual use.
