FR10 Product Sheet  

Section 1 - FireTect FR-10 Varnish
Manufacturer's Name: FireTect	Emergency Telephone Number: 661-298-8801
Address: 26951 Ruether  Avenue, Unit D	Telephone Number for Information:  661-298-8801
Canyon Country, CA 91351	Date Prepared:  01-06-98 Reviewed: 09-01-2006

Hazardous Components  (Specific Chemical Identity; Common Name(s))

OSHA PEL

ACGIH  TLV

Other Limits Recommended

%  (optional)

Section II - Hazard Ingredients/Identity Information

FireTect FR-10 Flame Retardant Coating - VOC 47 grams per liter Non-hazardous water based latex coating

NFPA:

Hazardous 0  Flammability 0

Reactivity 0  DOT Classification: None

21.8% Inorganic Phosphates 41.9% Liquid vehicle

18.4% modified polyvivylidene chlorid copolymer  3.4 % sodium salt aromatic sulfonate

Section III - Physical/Chemical Characteristics
Boiling Point	212ºF	Specific Gravity (H2O = 1)	1.08
Vapor Pressure (mm Hg.)	none	Melting Point	none
Vapor Density (AIR = 1) Equal to water		Evaporation Rate (Butyl Acetate = 1) Less than water
Solubility in Water: Dilutable in water
Appearance and Odor: Off white liquid, or special requested color.

Section IV - Fire and Explosion Hazard Data
Flash Point (Method Used): none	Flammable Limits: none	LEL:none	UELnone
Extinguishing Media For dry solids use water foam CO2 or dry chemical fire fighting apparatus
Special Fire Fighting Procedures
Unusual Fire and Explosion Hazards

(Reproduce locally)

OSHA 174, Sept. 1985

Section V - Reactivity Data
Route(s) of Entry:	Inhalation? Yes	Skin? Yes	Ingestion? Unlikely
Health Hazards (Acute and Chronic)Inhalation: Overexposure may cause irritation. If not breathing give artificial  respiration. Seek medical attention
Skin Contact: Cleanse affected areas with mild soap and water. If irritation develops, seek medical attention.  Ingestion: If drowsy or unconscious, place victim on left side with head down. Do not give anything by mouth.
Seek medical attention.
Carcinogenicity:	NTP?	IARC Monographs?	OSHA Regulated?
None according to Ames Test
Signs and Symptoms of Exposure
Medical Conditions Generally Aggravated by Exposure: If irritation or redness develops from exposure move victim away from source and into fresh air. Seek medical attention.
Emergency and First Aid Procedures

Section VI - Health Hazard Data
Stability	Stable	X	Conditions to Avoid: None
Incompatibility (Materials to Avoid)
Hazardous Decomposition or Byproducts
Hazardous Polymerization	Will Not Occur	X	Conditions to Avoid: None

Section VII - Precautions for Safe Handling and Use

Steps to Be Taken in Case Material is Released or Spilled Flush spilled material into suitable retaining areas or containers with large quantities of water. Small amounts may be absorbed into appropriate absorbant.

Waste Disposal Method: Dispose of product in accordance with applicable local, county, state, and federal regulations.

Precautions to Be taken in Handling and Storing: Keep containers in cool, dry area. Use and store with adequate ventilation.

Other Precautions Storage should not exceed 80 F or fall below 40 F. Do not allow to freeze.

Once containers are opened they should be used completely.

Section VIII - Control Measures
Respiratory Protection (Specify Type) Not mandatory
Ventilation	Local Exhaust	Special
	Mechanical (General)	Other
Respiratory Proctection (Specify Type): Wear mask during spraying.
Protective Gloves: Use of gloves that are impermeable to product is advised.	Eye Protection: Approved eye protection to protect  against eye contact or irritation is recommended.
Other Protective Clothing or Equipment
Work/Hygienic Practices: Wash hands with soap and water. It is recommended that clean water be available for flushing eyes and skin.

Page 2

* U.S.G.P.O.: 1986 - 491 - 529/45775